Factory Reset - Triax TMB 200 Manual Del Usuario

Programmable Multiband Amplifier
TMB 200 & TMB 200S
An external keypad and display is used to setup the unit. A USB cable is used to connect the unit and the
keypad.
- Select the value "-"
Running through the menus
( )
V
When the unit is powered on:
• the programme mode is in standby:
• by default, the system is configured as follows:
o UHF1 è 3 UHF filters
o UHF2 è 0 UHF filters
o UHF3 è 7 UHF filters
• all the UHF filters are deactivated (display "
• the attenuators are at zero.

Factory reset

If necessary, to revert to factory settings, follow the procedure below:
The unit erases all the programming parameters and switches to standby mode.
awi -july 14
Settings
Menu
/ Config
p
Running through the menus (
- Select the value "+"
- Save the value
- -
"),
Firmware
14a23
p
Firmware
upload
p
Factory
Menu
Reset
4
)
^
Factory
wait
TMB 200-V1