Choosing The Correct Filter - Emerson WorkShop WS1200DE0 Manual Del Usuario

Choosing the Correct Filter

WARNING: To reduce the risk of
damage to the Vacuum, do not run
motor with float in raised position.
A cartridge Filter should be present,
and positioned correctly during all
vacuuming operations to avoid
debris leaks and possible damage
to the vacuum motor.
There are a variety of Filters available for
WORKSHOP Wet/Dry Vacuums.
®
The Filters you choose should depend
upon the task you are performing.
Not all available Filters are included with
each model, but they may be purchased
as needed from retailers carrying
WORKSHOP Wet/Dry Vacuums or from
www.WORKSHOPvacs.com
The available Filters include:
1. Pleated Paper Cartridge Filters
a. The available Pleated Paper
Cartridge Filters include catalog
numbers WS21200F (Everyday Dirt),
WS22200F (Fine Dust), and
WS23200F (HEPA Media).
b. Each of these Pleated Paper
Cartridge Filters are intended for
cleaning up dry debris, however, a
small amount of liquid can be picked
up without damaging the Filter.
When maintained properly, small
amounts of liquids will not cause
damage to the Filter. When picking
up larger amounts of liquid, the
Pleated Paper Cartridge Filter will
become saturated and misting may
appear in the vacuum's exhaust.
After using the Vac to pick up small
amounts of liquid, the Pleated Paper
Cartridge Filter must be dried to
avoid mildew and damage.
OPERATION (continued)
c. If you are using your vacuum to pick
up very fine dust, it will be necessary
for you to empty the drum and clean
the Filter at more frequent intervals
to maintain peak vacuum
performance.
d. See "Filter Removal and Installation"
section for directions on how to
change the Pleated Paper Cartridge
Filter.
2. Wet Application Cartridge Filter
a. The available Wet Application
Cartridge Filter is catalog number
WS24200F.
b This Wet Application Cartridge Filter
is intended for cleaning up liquids
and wet debris only. It is NOT to be
used for any dry debris.
c. To maintain Filter performance, rinse
thoroughly with water after each use.
d. See "Filter Removal and Installation"
section for directions on how to
change the Wet Application
Cartridge Filter.
10