Caster/Caster Foot Assembly; Wet/Dry Vac Assembly - Emerson WorkShop WS1200DE0 Manual Del Usuario

CASTER/CASTER FOOT ASSEMBLY

With the power head and lid assembly
removed from the drum, and the drum
upside down on the floor:
1. Insert the 4 caster feet into the bottom
of drum, as shown on the 4 locations.
2. Push firmly on the caster foot until the
foot is flush with bottom of the dust
drum.
3. Insert the caster stem into the socket
of the caster foot, as shown
(4 places).
4. With a slight twisting motion, push on
the caster until the ball on the caster
stem is inserted all the way into the
socket. You will hear the ball snap into
the socket and the caster will swivel
easily when positioning is correct.
5. Turn the drum upright.
1. Locate the lid assembly and the dust
drum.
2. Position the lid assembly with the inlet
of the unit located in line with the drain
cap on the dust drum.
3. To assemble the lid assembly to the
drum, lower the lid assembly onto the
dust drum. Rotate both latches down
until you hear them snap over the lip
of the drum.
Drum Latch

WET/DRY VAC ASSEMBLY

Drum Latch
Drum Lip
Caster
Foot
Hole
Dust
Drum
Inlet
Lid
Assembly
Dust
Drum
Drain
Cap
6
Caster
Caster Stem
Caster Ball
Pin