Dyna-Glo DGG424CNP Manual Del Usario página 8

ASSEMBLY INSTRUCTIONS
3. Pre-assemble four M6x16 bolts (AA) onto
the cart bottom shelf assembly (P) and do not
tighten them. Make sure to leave a 5mm gap
between the bolt and the panel. Then hang
the cart left side panel assembly (M) and the
cart right side panel assembly (N) onto the
bolts and tighten the four bolts.
Hardware Used
AA
M6x16 Bolt
4. Attach the cart front brace (S) to the cart left
side panel assembly (M) and the cart right side
panel assembly (N) with four M6x16 bolts (AA).
Hardware Used
AA M6x16 Bolt
3
M
x 4
4
x 4
AA
8
M
S
AA
N
N