LEGRAND Watt Stopper RT-50 Instrucciones De Instalación página 2

INSTALLATION & WIRING
WARNING
Disconnect power to the wall switch box by turning OFF the circuit
breaker or removing the fuse for the circuit before installing the
RT-50, replacing lamps, or doing any electrical work.
1. Prepare the switch box.
After the power is turned OFF at the circuit
breaker box, remove the existing wall plate and
mounting screws. Pull the old switch out from the
wall box.
2. Identify the type of circuit.
In a Single Pole Circuit (see Fig. 1), two single
wires connect to two screws on the existing
switch. A ground wire may also be present
and connected to a ground terminal on the old
switch. A neutral wire should also be present in
the wall box.
For your safety: Connecting a proper ground to the time switch provides
protection against electrical shock in the event of certain fault conditions.
If a proper ground is not available, consult with a qualifi ed
electrician before continuing installation.
Only connect the RT-50 to a Single Pole Circuit. The RT-50 is not suitable for
3-way switching. If the existing wiring does not match the description for a Single
Pole Circuit, you should consult with a qualifi ed electrician.
3. Prepare the Wires.
Tag the wires currently connected to the existing
switch, so that they can be identifi ed later.
Disconnect the wires. Make sure the insulation
is stripped off the wires to expose their copper
cores to the length indicated by the "Strip Gage,"
in Fig. 2 (approximately 1/2 inch).
4. Wire the time switch.
Twist the existing
wires together with the
wire leads on the time
Black – > HOT (power
switch as indicated in
from circuit box)
the drawing. Cap them
securely using the wire
nuts provided. See Fig 3.
• Connect the green or
non-insulated (copper)
GROUND wire from the
circuit to the GROUND
terminal on the RT-50.
• Connect the power wire
from the circuit (HOT)
to the black wire on the
RT-50.
• Connect the power wire
to the lamp or fan (LOAD)
to the red wire on the
Fig. 3: Switch orientation, wire connections
RT-50.
• Connect the NEUTRAL wires
from the circuit to the white wire
on the RT-50.
5. Put the RT-50 in the wall box with the time selection buttons
positioned above the ON/OFF button.
Secure it to the wall box with the screws provided.
6. Attach the new cover plate.
7. Restore power to the circuit.
Turn on the breaker or replace the fuse.
www.wattstopper.com/athome
HOT (power from
circuit box)
NEUTRAL
LOAD
Ground
(power
to lamp)
Fig. 1: Typical Single
Pole Switch
Wiring
CAUTION
Strip Gage
1/2"
12.7 mm
Fig. 2: Wire Stripping
Red – > LOAD (power
to lamp or fan)
White – >
NEUTRAL
Green – > GROUND
Terminal
and wall box assembly