Reset Button; Specification - Lenco IPD-4600 Guia Del Usuario

2.Use a straightened paper clip, toothpick or similar objects to press the RESET button
located at the display module compartment of the main unit (see the below figure).
The reset operation clears the system memory and all of your previous settings will be
erased.
Power Adaptor :
Power Supply for the unit :
Backup battery for Clock and Memory : DC3V, CR2032 x 1 Lithium Battery (included)
Remote Control battery :
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE SET ARE SUBJECT
TO CHANGE WITHOUT PRIOR NOTICE.
If at any time in the future you should need to dispose of this product please
note that: Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
TUNE

Specification

For information and support www.lenco.eu
FUNC
VOLUME
Input AC 100V - 240V ~ 50 / 60 Hz
Output DC 15V 2400mA
DC 15V 2400mA
DC3V, CR2025 x 1 Lithium Battery (included)
16

RESET button