CAME MI6030 Manual De Instrucciones página 51

S40 series - ANTIPANIC application on FRAME and FIXED DOORS S40 series - ANTIPANIC application on FRAME and FIXED DOORS
S40 series - ANTIPANIC application on FRAME and FIXED DOORS S40 series - ANTIPANIC application on FRAME and FIXED DOORS S40 series - ANTIPANIC application on FRAME and FIXED DOORS
3
PM305
PM147
4
Fixed Frame
- Insert the upper angle elements with the adjustment
device (PM305 + PM148) in the frame section and
fasten the edge with the flathead screws provided.
- Insert the lower hinge brackets (PM147) in the
section and temporarily screw with the M6 socket
head screws counter to the frame section (this will
allow subsequent door aligning adjustments).
- Fasten the frame to the opening to be covered,
starting by fixing the angle elements and lower
brackets (bore holes at the points indicated in the
illustration with).
- Temporarily insert and align the "closed door"
magnetic microswitch (art. PM145 + REED)
PM148
4
Art. PM145/REED/MA302M
6
"Closed doors"
magnetic contact
PM996
PM993
Fixed Door
- Insert and fasten hinge parts (art. PM993...) and
the magnet (PM145).
- Insert the fixed doors to the wall-type frame,
square the doors with the frame and insert the spring
latch blocks (PM306), making sure the doors'
breakthrough side is correct. Align the microswitch
and the magnets and then connect the photoelectric
cell cables.
- Verify the correct operation of the latches by
moving them a few times.
PM306
PM997
4
PM997
PM306
- pg. 23 -