LaserLiner AutoCross-Laser 2 XP Manual Del Usuario página 16

Ocultar thumbs Ver también para AutoCross-Laser 2 XP:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
Checking the vertical line:
Position the device about 5 m from a wall. Fix a plumb bob with a line of 2.5 m
length on the wall, making sure that the bob can swing freely. Switch on the
device and align the vertical laser to the plumb line. The precision is within the
specified tolerance if the deviation between the laser line and the plumb line is
not greater than ± 1 mm.
Checking the horizontal line:
Position the device about 5 m from a wall and
switch on the cross laser. Mark point B on the
wall. Turn the laser cross approx. 2.5 m to the
right and mark point C. Check whether the
horizontal line from point C is level with point B
to within ± 1 mm. Repeat the process by turning
the laser to the left.
!
Regularly check the adjustment before use, after transport and after
extended periods of storage.
Technical data
Self-levelling range
Precision
Laser wavelength linelaser (red)
Laser wavelength linelaser (green)
Laser wavelength point laser (red)
Laser class
Power supply
Operating time ACL 2 XP / ACL 2 XPG
Operating temperature
Storage temperature
Protection class
Weight (incl. batteries)
Dimensions (W x H x D)
16
GB
(Subject to technical alterations 04.16)
B
± 3°
± 2 mm / 10 m
635 nm
510 nm
635 nm
2 / < 1 mW
4 x 1.5 V alkaline batteries
approx. 10 h / approx. 3.5 h
0°C ... + 45°C
-10°C ... + 70°C
IP 54
550 g
130 x 105 x 70 mm
2,5 m
C

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Autocross-laser 2 xpg

Tabla de contenido