Operating Instructions
1.
Place ingredients in glass jug (not past maximum level) and secure jug lid with
wide rim side sitting directly over jug handle.
2. Place the jug into the main blender unit with the jug handle directly over the
control panel.
3. Close lid of main blender unit and you will hear the magnets engage. Now you
are ready to begin vacuum blending.
Vacuum Blend MODE
1.
Plug cord into power socket. Lights will show on front of unit and the unit will
beep. Press the ON/OFF button to turn on.
2. Press the Vacuum Blender button and then the ON/OFF button again to start the
Vacuum Blend mode. The Vacuum Blend mode will begin by removing the air
from the jug and will then blend at varying speeds until programme is fi nished.
3. The blender will continue to beep until ON/OFF button is pressed.
4. When you have fi nished blending, turn blender unit off at power socket.
5. Unlock and open lid of main blender housing. Remove blender jug. Before
opening the jug lid, lift the red valve to release the vacuum pressure. Remove jug
lid and pour to enjoy.
6. To vacuum preserve the remainder of blender jug contents, transfer into the
vacuum jar and use Vacuum (Only) mode - instructions below.
Vacuum MODE
1.
Unlock and open lid of main blender housing.
2. Place ingredients into vacuum jar and attach the lid.
3. Close lid of main blender housing.
4. Press the ON/OFF button to turn on. Press Vacuum button and press ON/OFF
button again to start the Vacuum mode.
5. Programme will end when air has been optimally removed from vacuum jar.
Use the vacuum jar to preserve sauces, raw fruits and vegetables and many more
ingredients
Manual Speed / Pulse / Clean MODE
Fill jug with ingredients and place into main unit. Press ON/OFF to activate the blender.
•
Manual Speed: Press the + or - to select the speed from 1 to 9. Press ON/OFF button.
Blender will operate at selected speed until ON/OFF button is pressed again to stop.
•
Pulse: Press and hold the Pulse/Clean button in bursts until you have blended to the
desired consistency. Pulse mode will always operate at maximum speed setting.
To prevent overheating, never allow the blender to run
for more than two minutes at a time, as it can cause
Astro_Blender_Manual.indd 9
Astro_Blender_Manual.indd 9
permanent damage to the motor.
9
22/6/18 2:46 pm
22/6/18 2:46 pm