Kübler CODIX 130 Manual De Instrucciones página 9

Input specification, pin assignment and adjustable operating modes (DC versions).
A control input (screw terminal 5) allows adjusting the operating mode.
Screw terminal Nr. 1
Designation
Model
6.130.012.8x0 07 kHz
6.130.012.8x2 12 kHz
6.131.012.8x0 07 kHz
6.131.012.8x1 12 kHz
6.133.012.8x0 03 kHz
6.133.012.8x1 06 kHz
Table 2
Screw terminals 1 and 2:
Function and max. frequences(Pulse/Pause 1:1)
see Table 2
NPN : active for negative edge
Input resistance: approximately 1 MOhm
Low level: 0 ... 0,7 V DC
High level: 3 ... 30 V DC
Screw terminal 3:
Reset input, active for negative edge
Contact input / Open Collector NPN
(switching at 0 V DC)
Low level: 0 ... 0,7 V DC
High level: 3 ... 30 V DC
Min. pulse duration: 50 ms
Input resistance: approximately 2,2 MOhm
Screw terminal 5:
Operating mode switch (Mode)
Contact input / Open Collector NPN
(switching at 0 V DC)
Low level: 0 ... 0,7 V DC
High level: 3 ... 5 V DC
Input resistance: approximately 2,2 MOhm
Function: see Table 2
9
Nr. 2
INP A INP B
NPN 30 Hz NPN
PNP NPN
NPN 07 kHz NPN
PNP 12 kHz PNP
NPN 03 kHz NPN
PNP 06 kHz PNP
Nr. 3 Nr. 4 Nr. 5
Reset Reset Control inputs for operating
Enable
not active
=
adding
not active
=
Cnt.Dr Mode
not active
=
Quad Mode
PNP :
Input resistance:
Low level:
High level:
Screw terminal 4:
Electrical locking of the reset key
Contact input / Open Collector NPN
(switching at 0 V DC)
Low level:
High level:
Input resistance:
Input not active:
Input in contact
with GND:
Screw terminal 6:
GND connection common for all inputs
Screw terminal 7:
(–) external power supply for the LCD backlight option
Screw terminal 8:
(+) external power supply for the LCD backlight
option(24 V DC ±20%, 50 mA)
Nr. 6 Nr. 7
GND
mode (Mode)
contact with
GND =
subtracting
contact with
GND =
Up.Dn Mode
contact with
GND =
Quad2 Mode
active for positive edge
approximately. 100 kOhm
0 .. 0,7 V DC
4 .. 30 V DC
0 ... 0,7 V DC
3 ... 5 V DC
approximately. 2,2 MOhm
Reset key locked
Reset key unlocked
Nr. 8
BL BL
– +