Brewing With Cup Drawer - Bunn MY CAFE Manual De Uso Y Cuidado

BREWING WITH THE CUP DRAWER
1 . To open the Cup
Drawer Lid, hold the
Drawer handle and
lift the Lid Handle to
release the Lid. As you
lift the Lid, it will pivot
away to allow access
to the Cup Holder.
2. Insert K-Cup
the Cup Holder.
3. Close Lid and push
down firmly on the Lid
to properly puncture
the pack.
Make sure you snap the Lid
Handle down into place.
CAUTION: The Cup
Drawer has two
sharp points to pierce the
pack for brewing. Caution
should be used when using
or cleaning the Drawer to
prevent injury.
4. Slide Cup Drawer into
Drawer Guides and push
in to lock into place.
Cup Drawer must be
locked into place before
brewer will operate.
5. Open Spin Lid on top of
brewer.
K-Cup is a registered trademark of Keurig, Incorporated.
®
BUNN is not affiliated with Keurig, Incorporated.
pack into
®
5 5
6. Using your preferred
cup or measuring
device, fill Pour-In Bowl
with desired amount of
water (minimum 4 oz.,
maximum 14 oz.).
Note: the cup positioned
on Drip Tray and under
the Cup Drawer must be
larger than the amount of
water you pour inside.
7. Close Spin Lid on top of
brewer and position cup
on Drip Tray under Cup
Drawer.
Note: be sure cup is heat
resistant.
8. For regular brew, push
the Brew Button.
For bolder brew or for
tea, push the Pulse Button
to activate and then push
the Brew Button. Pulse
starts and stops the flow of
water several times during
the brew cycle and extends
the contact time for a
bolder beverage.
9. At end of brew cycle,
remove cup from
Drip Tray.
10. Remove Cup Drawer
and dispose of used
pack.
CAUTION: A small
amount of hot water
may pool on top of the
Cup Drawer Lid during
brew, so remove slowly.
To remove the Cup
Drawer press down on the
button located on the top
of the Cup Drawer handle
and pull Cup Drawer out
along the Drawer Guides.
Use the Lid Handle to lift
and pivot the Lid out of the
way so you can carefully
remove the used pack from
the Cup Holder. Dispose
of used pack in a waste
container.