flir MR04 Guia Do Usuário

Introduction
Thank you for selecting the FLIR Extension Pole Model MR04. When connected to a FLIR
Moisture probe such as MR05 Impact Pin Probe or MR06 Wall Cavity Probe, the MR04 allows
the user to measure moisture in wood and other building materials in difficult to reach areas
from a safe distance.
Safety Instructions
 This device should be used only for purposes outlined in this guide. Misuse may cause
damage to the MR04 and/or external devices, and can cause personal injury.
 Keep the extension pole packed when not in use. Note that the MR04 can be stored in the
MR07 or MR08 carry case for convenience.
 Do not allow children to handle the extension pole.
Description
1. Extender controls
2. Angle adjustment screw
3. Probe mount release buttons
4. Probe mount plate
5. Probe mount screw
6. Probe stabilizer
7. Probe mount screw dial
Operating Instructions
1. Carefully remove the MR04 extension pole from its packaging.
2. Press the release buttons (3) to remove the mount plate (4).
3. Connect the mount screw (5) to the probe and tighten with the dial (7).
4. The stabilizer notch (6) prevents the probe from rotating.
5. Reconnect the mount plate (4) to the extension pole.
6. Use the MR04 extender controls (1) to extend the pole to the desired length.
7. Use the angle adjustment screw (2) to set the desired angle.
8. Operate the moisture meter and probe as described in their user guide.
9. Hold the MR04 handle grip firmly when maneauvering the connected probe.
Specifications
o
Adjustment angle: ± 90
Dimensions: 47.8cm (18.83") collapsed; 134.3cm (52.88") extended; x 4 cm (1.6") x 5.5 cm (2.2")
Weight: 466g (1 lb.)
Compatible probes: MR05 Impact Pin Probe and MR06 Wall Cavity Probe
Warranty
FLIR Systems, Inc. warrants this device to be free of defects in parts and workmanship for 2 (two) years from date of
shipment providing:
 Device is purchased from FLIR Commercial Systems or an Authorized reseller
 Device is registered online at www.flir.com/test/warranty within 60 days of shipment
 FLIR is notified within 30 days of a defect being found
 Contact FLIR Return Material Authorization before returning the product for a Return Authorization number
 The sender is responsible for shipping charges, freight, insurance and proper packaging to prevent damage in transit.
This warranty does not apply to defects resulting from action of the user such as misuse, improper wiring, operation outside
of specification, improper maintenance or repair, or unauthorized modification.
FLIR SYSTEMS, INC. SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A SPECIFIC
PURPOSE AND WILL NOT BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
FLIR's total liability is limited to repair or replacement of the product. The warranty set forth above is inclusive and no other
warranty, whether written or oral, is expressed or implied. To read the entire 2 (two) year warranty agreement please visit
www.flir.com/test/warranty
For Technical Support: email TMSupport@flir.com or call +1 855‐499‐3662 (option 3)
Copyright © 2016 FLIR Systems, Inc. www.flir.com For additional languages visit www.flir.com/test
USER GUIDE
MR04 ‐ EXTENSION POLE
2
1
3
Document Identifier: MR04‐mul_AC 04/16
7
3
5 6
4