flir MR09 Guia Do Usuário

Introduction
Thank you for selecting the FLIR Moisture Meter Baseboard Probe Model MR09. When
connected to a FLIR Moisture Meter, the MR09 allows the user to take relative moisture
measurements behind trim pieces, baseboards, crown molding, and masonry; under tile, inside
walls/ceilings, and other such places where the sensor blades can be inserted. The blades are
designed to 'flex' into the measurement cavity eliminating the need to remove the obstacle
that would otherwise prevent a standard pin or pinless measurement. This probe is designed
to operate with FLIR Moisture Meters.
Safety Instructions
 This device should be used only for purposes outlined in this guide. Misuse may cause
damage to the MR09 and/or external devices, and can cause personal injury.
 Keep the MR09 packed when not in use. Note that the MR09 can be stored in the MR07 or
MR08 carry case for convenience.
 Do not allow children to handle the MR09.
Description
1. Conversion plate 9.5mm (3/8") mounting hole
2. Handle grip
3. Sensor blades
4. BNC cable jack
5. BNC to RJ45 connector cable
Operating Instructions
1. Carefully remove the MR09 from its packaging.
2. Connect the probe to the moisture meter using the supplied BNC/RJ45 cable (BNC
connection on probe and RJ45 connection on FLIR moisture meters).
3. Operate the Moisture Meter as described in its User Guide.
4. Hold the MR09 handle grip firmly when maneauvering the blades in the area to test.
Specifications
Blade material: 400‐series stainless steel; thickness: 1mm (0.04 in.)
Measurement type: Resistive moisture measurements for reference only
Penetration depth: 15cm (6 in.) maximum
Mounting hole: 9.5mm (3/8 in.) threaded
Cable length: 2.45cm (8 ft.)
Dimensions: 34 x 10 x 6cm (13.4 x 4.0 x 2.4 in.)
Weight: 494g (1.2 lbs.)
Warranty
FLIR Systems, Inc. warrants this device to be free of defects in parts and workmanship for 2 (two) years from date of
shipment providing:
 Device is purchased from FLIR Commercial Systems or an Authorized reseller
 Device is registered online at www.flir.com/test/warranty within 60 days of shipment
 FLIR is notified within 30 days of a defect being found
 Contact FLIR Return Material Authorization before returning the product for a Return Authorization number
 The sender is responsible for shipping charges, freight, insurance and proper packaging to prevent damage in transit.
This warranty does not apply to defects resulting from action of the user such as misuse, improper wiring, operation outside
of specification, improper maintenance or repair, or unauthorized modification.
FLIR SYSTEMS, INC. SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A SPECIFIC
PURPOSE AND WILL NOT BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
FLIR's total liability is limited to repair or replacement of the product. The warranty set forth above is inclusive and no other
warranty, whether written or oral, is expressed or implied. To read the entire 2 (two) year warranty agreement please visit
www.flir.com/test/warranty
For Technical Support: email TMSupport@flir.com or call +1 855‐499‐3662 (option 3)
Copyright © 2016 FLIR Systems, Inc. www.flir.com For additional languages visit www.flir.com/test
USER GUIDE
MR09 – BASEBOARD PROBE
5
3
2
1
4
Document Identifier: MR09‐mul_AA 03/16