THOMSON TT200 Manual Del Usuario página 9

Stereo phonograph operation
Please Note - Before Use
Remove the stylus protector.
-
Make sure that the tone arm is unlocked and free to move from the tone
-
arm rest prior to operating. Lock the tone arm again when not in use.
1. Raise the turntable dust cover (1).
2. Place the record on the platter (use the 45 RPM record adaptor if you are playing 45 RPM records).
3. Set the speed selector (9) to the proper position for the record you are playing.
4. Set the cueing lever (10) to the up position.
5. Lift the tone arm from the rest and slowly move it to the record side. The platter
will start to rotate and position the tone arm over the desired position of the
record.
6. Pull down the cueing lever (10). The tone arm will come slowly on the record
and start playback.
7. At the end of the record, the tone arm will return to the rest position
automatically.
8. To stop manually, lift the tone arm from the record and return to the rest.
Play suspension
Set the cueing lever (10) to the up position will life up the tone arm and then stop playback temporarily
Remark :
- Due to the auto return system was mechanical design and reset point will be affected after
transportation. Thus, the tone arm will return to the rest automatically when first time place it to the
platter and it was not the malfunction.
- Due to the length of the record is various, if you find the tone arm cannot return automatically after
playback of record. Please adjust the Tone arm stopping position as below.
- Users should not change to a magnetic cartridge system, otherwise unit can´t be connected anymore to
an aux-in of music-centre
Anti-skating adjustment
The anti-skating control (8) is made the stylus more stable and this relative to the different type of vinyl,
-
thus, just set it to the comfortable position as you desired.
Tone arm stopping position alignment
- The position of the tone arm complete playback and return to the rest station can be adjusted at the
alignment screw (6) as follow:-
Before starting the alignment, please take out the hole covering rubber:-
a) If the system cannot complete the playback of record and return earlier, use a cross head screw driver
and turning the alignment screw (6) inside the hole clockwise, the stopping and eject position of the tone
arm will move more inward to the center of the record for playback completion.
OPERATIONS
3