Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
"SAVOY MK2" - model : 134 08 09
C
B
A
Figure 3 - Top flue outlet
-
The flue must be in good condition and must provide
sufficient draught.
-
The flue must be suitable for the installation of solid
fuel burning appliances and comply with Current
Building Regulations.
-
The flue must be clean. It should be swept to remove
soot and dislodge tar deposits.
-
The flue must be well insulated. If the flue inner wall
surfaces are cold, a good thermal draw is impossible
causing condensation problems (tar formation etc...)
to occur.
-
The flue must not be shared with other appliances.
-
The chimney must be at least 4.5 m (15 ft high).
-
In case of a flat roof or when the roof gradient is lower
than 15°, the stack must be 1,2 m (4 feet) high at least.
-
If the chimney has any down draught tendency, due to
its position in relation to nearby obstacles, then an
anti-down draught cowl must be installed on the
chimney or the chimney height must be increased.
-
If the decompression in the chimney is excessive, a
draught stabiliser must be installed.
Chimney to be built / New flue : The chimney must
comply with Current Building Regulations. If in doubt,
consult your Dealer or local Building Inspector.
-
The appliance must not support the weight of the flue.
-
It must be distant from any combustible material
(walls, cross members).
-
It must permit an easy sweeping.
2.4 Mounting the flue collar
The stove is supplied with a connection flue spigot with
an inner diameter of 125 mm and an outer diameter of
139 mm. The stove is set from the factory with a top
outlet.
2.5 Top flue outlet
Figure 3
-
First remove the flue baffle (A).
-
The stove is set from the factory with a top outlet.
-
Do not remove the cast iron top.
Technical manual "1274"
1
2
A
D
B
A
A - Flue baffle
B - Gasket
C - Flue collar
D - Blanking plate
Figure 4 - Rear flue outlet
Figure 5 - Cut-out in the rear heat shield
-
Fit the sealing rope (B) in the groove and attach the
flue spigot (C) on the top using the bolts and washers
supplied, ensuring there is a good seal.
-
Refit the flue baffle (A).
2.6 Rear flue outlet
Figure 4
-
Do not remove the cast iron top.
-
remove the cardboard chock from the top.
-
Remove the internal baffle A.
-
Remove the rear heat shield F.
-
Remove the flue precut part in the heat shield
(figure 5).
-
Removed the flue spigot C.
-
Place the seal rope B within the groove, fix the
blanking plate D and the clamp E and ensure a good
tightness.
-
Place the seal rope B within the groove, screw into
position the Flue collar C and ensure a good tightness.
-
Replace the rear heat shield F.
-
Refit the flue baffle A.
Installation instruction
C
E
B
1
2
A
F
E - Clamp
F - Back panel
5
Publicidad
Capítulos
Tabla de contenido
