List Of Features - IKEA KLASEN Manual Del Usuario

8
contact your gas supplier.
• Avoid that the hole on the cover (VENT) is
obstructed or stopped(2).
• This regulator is not for use in caravans
and motor caravans.
Fitting the regulator on the valve
Make sure that:
• All the taps of the user appliance are
closed.
• The rubber hose is correctly fastened to
the regulator and user appliances.
• Make sure the handle is in the "closed"
position (this happens when on the handle
is visible a red rectangle with the marking
"OFF") (Fig2).
• Remove the plastic protective plug from
the automatic valve.
• Pull the ring (3) upwards as shown in
figure 3 and fit the KOSAN 35 onto the
valve. Afterwards give the ring (3) a
strong push downwards as shown in
figure 4. A "CLICK" should be heard,
meaning the regulator has been correctly
fitted.
Operation
OPEN (ON): After correctly fitting the
regulator onto the valve, the gas flow
can be opened by turning the knob a
half turn counterclockwise until the
stop, until you reach the opposite
horizontal position. In this position a
red flame with "ON" is visible as
shown in figure 5. In this position the
valve is opened and the gas flow is
allowed.
CLOSED (OFF): The gas flow can be
stopped by turning the knob a half
turn clockwise until the stop, until you
reach the opposite horizontal position
"OFF". In this position the valve is
closed.
Replacing the gas cylinder
Make sure that:
All taps of the user appliance are closed.
The opening knob of the KOSAN 35 is in the
closed position (by turning it a half turn until
the stop, the red flame is not visible, "OFF").
Afterwards, remove the regulator by pulling
the ring(3) as shown in figure 6. Note: it is
not possible to pull the ring until the knob
is in the horizontal position and the marking
"OFF" is not visible. This is an important
security feature. The user must not try to
pull the regulator ring if the knob is not in
the "OFF" position. Please contact your gas
supplier if you have any problem.
System maintenance
• To ensure correct operation of the flow
limiting device during gas supply, the
appliances hose length should be 1.5m at
maximum.
• If the system is not used for long periods
of time (e.g., in winter), disconnect the
pressure regulator of the tank. Protect the
pressure regulator to prevent any flying
mud.
• Normally the hose must be changed every
5 years.
• In normal conditions of use, to ensure
correct system operation, it is best to
replace the pressure regulator every
10 years from the date of startup. The
pressure regulator must conform to the
EN12864 standard.
• When replacing the pressure regulator or
the hose, it may be necessary to replace
the clamps.
• After performing any maintenance
operations, always check the seal of the
system before starting it again.
• The pressure regulator does not require
any special maintenance jobs, but always
make sure the vent(2) is not blocked. If
it is blocked, it can be freed by means of
a needle.

LIST OF FEATURES

The numbering of the product features
shown refers to the illustration of the
barbecue on the graphic page.
1. Handle
2. Hood
3. Cooking grill
4. Burners
5. Vaporizer bars
6. Grease tray
7. Control knobs
8. Barbecue body
USER INSTRUCTIONS
Before proceeding, make certain that you
understand the WARNING statements in this
manual.
• Preparation before cooking – To prevent