Keypad Layout - Nice Seld Manual De Instrucciones

A) Open the battery holder so you can see the 1
B) The 2 fixing hole is accessed through the cover compartment
nd
E) Use the screws provided to fix the selector
F) Close the battery holder and put the top cap back in place.

4) KEYPAD LAYOUT

The keys have the following functions:
This is the only key that goes from the Waiting to the Active state so that all
the functions can be used. When using the selector this key should not be pressed again
unless you wish to reset the current operation to start another. From what has been said
we can deduce that the
contain the numbers from
The "Active" state lasts for 5 seconds after the last key was pressed.
It will return to the "Waiting" state as soon as the 5 seconds have elapsed.
÷ These keys are used to enter the combinations that activate transmission of
the recorded codes or they enable the programming procedures.
or By pressing one of these two keys, if preceded by the combination assigned
to them, transmission of the corresponding code will be enabled (
( second channel ). If, instead, the combination is wrong an acoustic signal will sound
and SELD will return to the Waiting state.
The key is also used as an operation confirm" key during the various programming
procedure phases.
key cannot be part of a combination (combinations can only
to ).
- 20 -
st fixing hole
first channel)