Style selections 48438 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1. Removing old vanity (if applicable): Turn off the
water supply and drain the P-trap. Disconnect
the supply lines from the faucet and disconnect
the P-trap. Remove the old vanity top and vanity.
If the vanity base (B) is not installed immediately,
temporarily stuff a rag into the drain pipes.
Provide sufficient protection on the floor to
protect the vanity base (B) from damage.
Tilt the vanity base (B) backward and remove
the shipping feet from the bottom of the vanity
base (B) using a pair of pliers (not included).
2. Attach the knobs (BB) using (2) 1 in. screws
(AA) to the vanity base (B).
Hardware Used
AA
1 in. screw
Knob
BB
3. Using a level (not included), locate any uneven
floor and/or wall areas where the vanity base (B)
will be installed. Unevenness can cause the
vanity base (B) to become misaligned,
resulting in twisting of the cabinet. Repair any
uneven areas by reducing high spots or
shimming low spots. Place the vanity base (B)
in the desired position, taking into account the
location of the plumbing. It is recommended the
vanity base (B) be installed to at least 1 wall stud.
In order to locate wall studs, you can use a stud
finder (not included) or tap along the wall until
you find a spot that sounds solid. If you are
unable to locate a wall stud, it is recommended
you use wall anchors (not included) to secure
the vanity base (B).
1
2
x 2
x 2
3
4
BB
AA