Tabla de contenido
Publicidad
●
D
●
O
FIG. 12
●
D
●
O
FIG. 14
●
●
Q
P
10
FIG. 16
●
D
FIG. 13
●
P
FIG. 15
●
Q
●
R
FIG. 17
ENGLISH
ROUTINE MAINTENANCE
●
Note: Turn off the switch
N
before routine maintenance. Never operate the vacuum
cleaner without the top
Note: When vacuuming carpet fresheners or cleaners, powder,
plaster dust, or similar fine substances, the top and bottom
filters will require more frequent maintenance.
Removing the Dust Cup
●
D
Step 1: Remove dust cup
by sliding dust cup lever
left (FIG. 12).
●
D
Step 2: Grasp dust cup
with both hands and pull out (FIG. 13).
●
D
Step 3: Empty dust cup
into trash.
●
Step 4: Reposition dust cup
D
●
O
lever
from left to right (FIG. 14).
Top Filter Maintenance
This new Eureka Upright uses a cyclone system as a primary filter and a
secondary or top mounted filter that has been moved outside of the dirt
cup. This makes emptying the dirt cup much easier and less messy. It is
normal for this filter to trap fine particles, pet hair, and carpet fuzz. It
should be cleaned periodically depending on vacuuming conditions. For
optimum performance replace it every 12 months.
Step 1: Remove top filter cover
the left (FIG. 15).
●
Step 2: Remove filter frame
Q
●
R
Step 3: Remove foam
from filter frame (FIG. 17). Shake filter
●
Q
frame
and foam filter to remove excess dust. If necessary, the
filter frame and foam filter can be rinsed in luke warm water and
air dried.
Note: The filter frame, foam and cover are not dishwasher
safe.
Step 4: When dry, replace foam filter
●
Q
Step 5: Replace filter frame
cover by pivoting back onto cleaner from left to right.
WARNING: Always check foam filter and frame are correctly
installed in the cover before using vacuum.
(CONTINUED)
and unplug the electrical cord
●
●
R
S
and bottom
filters in place.
●
O
from right to
in cleaner body and secure by moving
●
P
by grasping right edge and pivoting to
●
from top filter cover
P
(FIG. 16).
●
●
R
Q
into filter frame
.
●
P
into top filter cover
. Replace top filter
●
E
Publicidad
Tabla de contenido
