Battery Replacement - Tripp-Lite SmartPro SLT SMART1050SLT El Manual Del Propietario

200308025 Smart1050-1500SLT Owner's Manual.qxd
Basic Operation
(continued)
Rear Panel
continued
Input Breaker: Protect your electrical circuit from overcurrent draw
from the UPS load. If this breaker trips, remove some of the load,
then reset it by pressing the breaker in.
External Battery Connector (Select Models Only): Use to connect
Tripp Lite external battery packs for additional runtime. The specifi-
cations section of this manual lists the Tripp Lite external battery
packs that are compatible with your model. Refer to instructions
available with the battery pack for complete connection information
and safety warnings.
AC Input Receptacle: Connect one end of the detachable line cord
into this receptacle and the other end into your wall outlet.
"SITE WIRING FAULT" LED: This red LED will be lit if the UPS
detects a problem with the wiring of the AC outlet you connect it to.
If this occurs, have the outlet inspected by a qualified electrician.
Note that while the UPS will detect many common wiring faults,
including a missing ground, reversed polarity and overloaded neutral
circuits, it cannot detect every conceivable wiring problem.
11/14/2003 11:40 AM Page 8
8

Battery Replacement

Under normal conditions, the original battery in your UPS will last several
years. Contact Tripp Lite for information about replacement batteries.
Carefully pull the front panel down, out
1
1
and away from the UPS.
Be careful not to accidentally disconnect the ribbon cable connecting
the front panel to the rest of the UPS. Place the front panel on top
of the UPS, out of the way.
Unlock and lower the battery door.
2
Carefully pull the batteries from the UPS.
3
2
Replace batteries.
Carefully disconnect the old batteries from the UPS, then connect
the new batteries exactly as the old ones were connected, positive
(red) connectors together and negative (black) terminals together.
Reassemble UPS.
3
Reverse Steps 1-3, above.
9