Craftsman 580.752381 Instrucciones De Uso página 11

9. Move throttle lever ( A)to"Fast" p osition, shown a sa
rabbit.
10. Move choke lever ( B)to"Closed" position.
" _ OPEN
CLOSED
NOTE:For a warm engine, be sure the choke lever is in the
"Open" position.
11. Move engine switch (C) to "On" position.
E
OFF
I1,
ON
IMPORTANT:Beforestarting the pressure washer, be sure
'ou are wearing adequatesafety goggles.
_i, WARNING Risk of eye injury.
Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVERsubstitute safety glasses for safety goggles.
12. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance.Then pull rapidly
to start engine.
jJ
/j"
/ j
i
I
, \
,/"
/
z--
,i
i,
[
\
_i, WARNING Starter cord kickback (rapid retraction) can
result in bodily injury. Kickback will pull hand and
_,_. arm toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
• NEVER pull startercordwithoutfirst relievingspraygun
pressure.
• Whenstartingengine,pull cordslowlyuntil resistance isfelt
andthenpull rapidlyto avoidkickback.
• Aftereachstartingattempt,whereengine fails to run,always
pointspraygun in safedirection,pressred buttonandsqueeze
sprayguntriggerto release highpressure.
• Firmlygraspspraygun with both handswhenusinghigh
pressure sprayto avoidinjurywhenspraygun kicks back.
3. Return recoil starter slowly. DO NOT let rope "snap
back" against starter.
14. When engine starts, slowly move choke lever to "Open"
position as engine warms. If engine falters, move choke
lever to "Closed" position, then to "Open" position.
15. If engine fires, but does not continue to run,always point
gun in safe direction, press red botton and squeezespray
gun trigger to releasehigh pressure. Move choke lever to
"Open" position, and repeatsteps 12 through 14.
16. If engine fails to start after six pulls, move choke lever to
"Open" position, and repeatsteps 12 through 14.
NOTE:Always keep the throttle lever in the "Fast" position
when operating the pressure washer.
11