Craftsman 580.752381 Instrucciones De Uso página 17

3. Remove spray t ipfromend ofnozzle e xtension.
4. Use asmall paper cliptofree anyforeign m aterial
clogging o r restricting spray t ip(A).
5. Remove nozzle e xtension fromspray g un.
6. Using a garden h ose, r emove additional debris b yback
flushing w ater through n ozzle e xtension. Back f lush
between 30to60seconds.
7. Reinstall spray t ipintonozzle e xtension.
8. Reconnect nozzle e xtension tospray gun.
9. Make s ure garden h ose isconnected towater i nlet.
Check thathigh pressure hose isconnected tospray g un
andpump. Turn onwater.
10.Start e ngine f ollowing i nstructions
How to Start Your
Pressure Washer.
11. Test pressure washer by operating with each quick
connect spray tip.
O-Ring Maintenance
Purchasean O-Ring RepairKit at your local Searsor by calling
1-800-4-MY-HOME(46g-4663) or online at www.sears.com. It
is not includedwith the pressurewasher.This kit includes
replacemento-rings, rubberwasher and water inletfilter. Referto
the instruction sheetprovidedin the kit to serviceyour unit's
o-rings.
A WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVER repairleakingconnections with sealant o f any kind.
Replace o-ring or seal.
Pump Maintenance
ChangingPumpOil
Changeoil after first 50 hours of operation and then every
200 hours or 3 months, whichever occurs first.
NOTE:When changing pump oil, use only high quality
nondetergent 30 weight oil. Use no special additives.
Changepumpoil as follows:
1. Cleanarea around brass oil drain plug at bottom of
pump.
2. Remove oil drain plug. Drain oil completely into an
approved container.
3. When oil has completely drained, install oil drain plug
and tighten firmly.
4. Cleanarea around pump oil dipstick. Remove dipstick
and fill pump with recommended oil to "Full" mark on
dipstick (typically 0.35L or 12 oz.).
5. Install pump oil dipstick.
6. Wipe up any spilled oil.
17