Placing And Unpacking - Vestfrost VLS 026 RF SDD Instrucciones Para El Uso

GB

Placing and unpacking

Unpacking
Unpack the appliance and check that it
has not been damaged. If you observe any
damage, please inform your supervisor.
Placing
Install the appliance in a dry and well ventilat-
ed place. Avoid installation near heat sources
or in direct sunlight.
Place the appliance on the floor and make
sure that it is level.
Adjustable feet
Level the appliance by screwing the adjust-
able feet up or down.
If the appliance is to be placed on a soft sur-
face, e.g. floorboards or a carpet, it is best to
recheck whether the appliance is still level af-
ter a period of time as the underlying surface
may give under the weight of the appliance.
Room temperature
The appliance is designed and adjusted to
produce an optimum temperature level in the
vaccine compartment at a minimum/maximum
ambient temperature of +5°C to +43°C.
NOTE: The appliance must not be placed in
ambient temperatures below +5°C.
NOTE: Updated WHO PQS specifications:
The temperature specifications of the vaccine
storage refrigerator allow brief deviations from
the general target of +2°C to +8°C.
The Climate Class is indicated on the rat-
ing plate.
Climate class:
0, 1, 2, 3, 4, 6 ,8 = ambient 32°C
Climate class
5 and 7
NOTE: There must be free access to the
ventilation grille. (On the backside.)
Important:
Do not use open fire or cigarettes in the
fig. 2
proximity of the appliance.
Ventilation
It is important that the appliance is placed-
well ventilated, so that air can circulate
unhindered above, below, and around the
appliance. Fig. 2 illustrates how the neces-
sary air circulation can be ensured. There
must be at least 30 mm clearance between
the base of the appliance and the floor.
Ventilation openings in the appliance or in
built-in structures must be kept clear.
6
= ambient 43°C
fig. 3