Campbell Hausfeld XT200000 Manual Del Usuario página 9

rated at or above tool rated RPM.
8. Always use attachments designed for use with air powered tools. Do not
use damaged or worn attachments.
9. Never trigger the tool when not applied to a work object. Attachments
must be securely attached. Loose attachments can cause serious injury.
oil and sharp edges. Replace any hose that is damaged, weak or worn.
10. Protect air lines from damage or puncture.
11. Never point an air tool at oneself or any other person. Serious injury
could occur.
12. Check air hoses for weak or worn condition before each use. Make sure
all connections are secure.
install, service, relocate or perform any maintenance.
13. Keep all nuts, bolts and screws tight and ensure equipment is in safe
working condition.
14. Do not put hands near or under moving parts. Keep hands off guard
when operating. Do not operate tool without guard properly secured.
15. Always secure workpiece in a vise or clamp.
awkward positions and repetitive work motions can cause injury to hands
and arms. Stop using any tool if discomfort, numbness, tingling or pain
occur, and consult a physician.
during first few seconds of operation after an airtool has been lubricated.
Failure to cover exhaust port can result in serious injury.
Cut-off wheels must be securely fastened to the
tool. Only use 3 inch max. diameter cut-off wheels
Use of a whip hose prevents accidental triggering of
tool when pressurized air is connected to system.
Never carry a tool by the hose or pull hose to move
tool or a compressor. Keep hoses away from heat,
Release all pressure from the system before
pressure from the system before attempting to
Do not misuse this product. Excessive exposure to
product. Excessive exposure to vibration, work in
This air tool requires lubrication before initial use
and before and after each additional use.
Disconnect air tool from air supply before
lubricating.
Cover exhaust port with a towel before applying air
pressure. Oil will discharge through exhaust port
7