Temperature Control; Before Ironing - Rowenta FIRST CLASS DA1500 Instructivo De Operación

Ocultar thumbs Ver también para FIRST CLASS DA1500:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

20. This appliance was set at the factory to operate at 120 volt. Refer to the Operating
Instructions section of this manual for conversion to 240 volt operation.
21. Travel iron, is not intended for regular use.
22. Cleaning and user maintenance shall not be made by children without supervision.
SAVE THESE INSTRUCTIONS
nvironment protection first !
E
 Your appliance contains valuable materials which can be recovered or recy-
cled.
  Leave it at a civic waste disposal centre.
DESCRIPTION
1.
Voltage selector
(120/240 V)
2.

Temperature control

3.
Steam switch
4.
Microsteam200 soleplate

BEFORE IRONING

Remove the sticker on the soleplate or the soleplate protector*.
Adjust the voltage selector.
• Adjust the iron to correct voltage for your
location, using a sharp object.
If the voltage selected is 120 V, the iron
will operate at 100 to 120 V.
If it is set at 240 V, the iron will operate
at 200 to 240 V.
Note! If necessary, check that you are using an adapter which meets the safety
requirements of the country you are in.
Put the handle into the ironing position.
• Press the release button on the rear side
and raise the handle until it locks into
position.
• For storing press release button
again to close the handle.
*Depending on the model: these accessories are specific to certain models or available as an option.
5.
High precision tip
6.
Folding handle
7.
Water filling inlet
8.
Burst of steam button
9.
Handle release
4

Publicidad

Tabla de contenido
loading

Tabla de contenido