Ink Safety Instructions - Epson L220 Instrucciones De Seguridad Importantes

■
Do not touch the flat white cable and ink tubes inside the product.
■
Do not move the print head by hand; this may damage the product.
■
Do not put your hand inside the product while it is printing.
■
Do not spill liquid on the product or use the product with wet hands.
■
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
■
Do not press too hard on the scanner glass when placing originals.
■
Do not open the scanner section while the product is copying, printing, scanning, or
performing any other functions.
■
Be careful not to trap your fingers when closing the document cover or scanner unit.
■
Except as specifically explained in your documentation, do not attempt to disassemble or
service any part of the product yourself.
■
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
■
Before transporting the product, make sure that the print head is in the home (far right)
position.
■
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak.

Ink Safety Instructions

■
This product was originally designed to work with genuine Epson inks. Your product may not
function properly if you use other types of ink and may affect Epson's warranty.
■
The included ink bottles must be used for printer setup and are not for resale. The printer ships
with full ink bottles and part of the ink from the first bottles is used to charge the print head.
Yields vary considerably based on images printed, print settings, paper type, frequency of use,
and temperature. For print quality, a small amount of ink remains in the tank when the
product indicates it is time to refill the ink.
■
The ink bottles that came with your printer have a lower yield due to the ink charging process.
This process is carried out the first time you turn on the printer and guarantees better
performance. Do not load paper before refilling the ink tanks.
■
Keep ink bottles and the ink tank unit out of the reach of children. Do not allow children to
drink from or handle the ink bottles and bottle caps.
■
Even if any of the ink bottles are dented, the quality and quantity of ink is unaffected and can
be used safely.
■
Do not tilt or shake an ink bottle after removing its seal; otherwise, ink may leak.
10
Important Safety Instructions