Mitsubishi Electric MAC-397IF-E Para El Instalador página 31

(For details oneach s ystem, see the relevant instruction manual.)
Replace the interface unit O mounting cord clamp with asupplied mounting cord clamp 0-0 based on the thickness ofthe
connecting cable u sed f or e ach s ystem.
Interface unit
O mounting cord clamp or mounting
Mounting screwsO3.Sx12 \__cord clamps 0-0
Connecting cable for each system [_
The cables connected to the Indoor Unit should be mounted on or near the Indoor Unit.
If the connecting cable is not securely mounted, the connector may detach, break, or malfunction.
Mounting cord clamp O
EleCk_a, wire mounting
Mounting screws @ 4 x 16
Mounting screws @ 4 x 10
Mounting cord clamp @
• Set the interface dip switch (SW500-502) settings before turning on the power.
• If the interface dip switch (SW500-502) settings are not set correctly, the system will not function properly.
4.1. Centralized Control (When Connecting to a Centralized on-off remote Controller)
Indoor unit
Interface unit 0
TC1
TC2
TM1
TM2
* Centralized on-off
remote controller Q
_ Power supply
_]____I _ _ ~/N220-240V
_r ID S0/60 Hz
® 2_
_) GJund
\ Extend the cord using the extension
cord 0 at the installation site.
Refer to the installation manual of centralized on-off remote controller.
• swsoo
Setting required
• SW501 and SW502 do not have to be set.
SW501 SW502
ON
5