Mitsubishi Electric MAC-397IF-E Para El Instalador página 39

When mounting the interface to the back-side dent of MFZ-KA model, be sure to apply insulation material to prevent condensa-
tion from forming.
The Interface unit should be placed in a location where the connecting cable from the interface can reach an indoor unit.
The device will not function properly if the connecting cable is extended so the connecting cable should not be extended.
Mount the interface unit securely to a pillar or wall using 2 or more screws.
• When Using Wall Mounting Brackets 0
1 Attach the wall mounting brackets O to the interface unit
0 using 2 mounting screws 0.
Interface unit O Wall mounting
@
2
Mount the unit to a pillar or wall using 2 mounting screws 0.
_%]_ _ Cord clamp for
Mount_nt_l !_T¢:_ _ ! I__ iilgnt,n_ screws ,
g screws O
• When Mounting Directly to a Wall
Mount the interface unit 0 case to the wall using the mounting
screws 0.
Interface case
mounting screws @
Mounting
screws O
When mounting the interface unit 0 using a cushioning
material O, be sure to mount it in a location where it will not
fall.
Interface unit O _,_
//
When mounting the interface unit O inside a ceiling
or wall, install an access door to facilitate mainte-
nance.
// When the interface unit O is mounted
/ above an indoor unit, it should be
// _ positioned 40 mm or more away from the
unit to ensure that ceiling grills can be
_,,-/ removed.
0 mm or more
////_ Attach the interface unit O connecting cable here.
Store extra connecting cable in the ductwork space
behind the indoor unit.
/_ _ If there is any slack in the connecting cable, use a
fastener • to keep it in place.
Cushioning material 0
Input voltage 12 V --
Power consumption 2 W
Input current 0.15 A
13