Mitsubishi Electric MAC-397IF-E Para El Instalador página 38

• SW502 : Air Conditioner Function Settings
(Set this switch based on the functions of the M series connected to this device.)
M series
sw No. Functions OFF ON Comments
No. 1 Availability of a heating mode Combined cooler and Cooling unit only
heater
No. 2 Not in use Permanently set to ON.
No. 3 Not in use Permanently set to ON.
No. 4 Not in use Permanently set to ON.
No. 5 Not in use Permanently set to OFK
No. 6 Not in use Permanently set to OFK
No. 7 Not in use Permanently set to OFK
No. 8 Availability of a fan (Cooling model only) Has a fan or mode No fan or mode ON
OFF
P/S series
sw No. Functions OFF ON
No.1 Cooling only type/Heat pump type Heat pump type Cooling only type
No.2 Auto mode
No,3
No.4
No.5 Vane
Fan speed
Not available
(setting No. 3
disabled)
Available
(unit)
4 speeds
Available
Available
(setting No. 3
enabled)
Available
(remote controller)
3 speeds (2-speed
model set ON)
Not available
No.6 Swing Available Not available
No.7 Not in use Permanently set to OFF.
No.8 Fan mode Not available Available Set to ON.
Fan speed 2 step model : An actual fan speed is 2 step though the display of remote controller becomes 4 step or 3 step.
Comments
Set the mode in accordance with the operation
manual for the indoor unit.
Heat pump type :Set to ON.
Cooling only type :Set to OFK
Set to OFF.
When operating a 2-speed model with the 3-speed
setting (ON), the MA remote controller display will
indicate 3 tan speeds. The table below shows the
displays and the actual outputs at that time.
Display Meaning Indoor unit output
III Low speed Low speed
II II Medium speed High speed
iiiiii High speed High speed
The Vane function or either or indoor unit :
When the function is provided, it is Available (OFF).
When the function is not provided it is Not avail-
able (ON).
The Swing function of either of indoor unit :
When the function is provided, it is Available (OFF).
When the function is not provided, it is Not avail-
able (ON).
• Interface status monitor
You can check the status of the interface by the LED lamp on the interface unit board.
LED lamp no. Lamp off Lamp on Blinking
LED521 DC 12 V is not being supplied from the DC 12 V is being supplied from the air
air conditioner, conditioner.
LED522 Device is not communicating properly _ Blinking at approx. 1 second intervals: Device is
with the air conditioner, communicating normally with the air conditioner.
LED523 Device is not communicating properly _ Blinkingatapprox.8 second intervals: Device is com-
with the MA remote controller, municating normally with the MA remote controller.
Use the table above to check the device operations.
12