Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORIES
WARNING
Accessories other than those shown below can
lead to malfunction and resulting injuries.
STANDARD ACCESSORIES
1
1 Eye protection ..........................................................1
2 Allen wrench for M5 screw .......................................1
OPTIONAL ACCESSORIES ... sold separately
Sequential Trip Mechanism Kit
(Single Shot Parts)
Pneumatic Tool Lubricant
1 oz. (30 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change without any
obligation on the part of metabo HPT.
APPLICATIONS
Construction work such as wall sheathing, roof
decking, subfl ooring.
Mobile and modular home construction.
Making wooden boxes, and expendable pallets.
BEFORE OPERATION
Read section titled "SAFETY" (pages 4 – 8).
Make sure of the following before operation.
WORKING ENVIRONMENT
WARNING
No fl ammable gas, liquid or other fl ammable
objects at worksite.
Clear the area of children or unauthorized
personnel.
000Book_N5008AC2_US_metabo.indb 11
000Book_N5008AC2_US_metabo.indb 11
AIR SUPPLY
2
1. Power source
Use only clean, dry, regulated compressed air as a
power source for this Stapler.
Air compressors used to supply compressed air to
(Code No. 876762)
this Stapler must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
(Code No. 877153)
Standard For Compressors For Process Industries."
(Code No. 874042)
Moisture or oil in the air compressor may accelerate
(Code No. 876212)
wear and corrosion in the Stapler.
Drain daily.
2. Filter-Regulator-Lubricator
Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
Filter-regulator-lubricator units supply an optimum
condition for the Stapler and extend the Stapler life.
These units should always be used.
Filter .............The fi lter removes moisture and dirt
Regulator ......The regulator controls the operating
Lubricator .....The lubricator supplies an oil mist to the
DANGER
NEVER use reactive gases or
other
bottled
Explosion may occur.
WARNING
Never connect Stapler to pressure which
potentially exceeds 200 psi (13.7 bar 14 kgf/cm
if a regulator fails.
Never use non relieving coupler on Stapler.
).
2
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
pressure for safe operation of the Stapler.
Inspect the regulator before operation
to be sure it operates properly.
Stapler.
Inspect the lubricator before operation
to be sure the supply of lubricant is
adequate.
Use metabo HPT pneumatic tool
lubricant.
English
gases.
)
2
11
2018/03/19 16:30:27
2018/03/19 16:30:27
Publicidad
Tabla de contenido
