Please review the back of this card for a detailed illustration of the following
components:
Button
•
Charge battery as needed (rechargeable units only).
•
Turn the instrument ON with the
self test and will warm up and show info & set points.
•
A blocked flow test must be performed before use. See section 4.2 of the
manual.
•
Fresh Air Setup: press buttons corresponding with 'YES' or 'NO' on the
display.
•
To
page
Normal Operation screen, follow display instructions and press
corresponding buttons to advance to next page.
•
To reset alarms press
•
Perform a Calibration Check daily for each installed sensor per
section 3.8 of the manual.
•
To calibrate: ensure you are in fresh air and press and hold the
and follow instructions on the screen. See section 3.9 of the manual for
complete calibration instructions
•
To activate/deactivate MotionAlert
MotionAlert
•
To activate InstantAlert
•
Turn the instrument OFF by holding the
This quick start card provides only a brief description of the operating
instructions for the ALTAIR 5 Multigas Detector Alarm. The user of this
instrument must be fully aware of the limitations and instructions
supplied in the operating instruction manual. Failure to follow the
instructions may lead to serious personal injury or death.
8021 Rev. 1
Multigas Detector Quick Start Card
Button
through
the
button.
TM
screen and follow display instructions.
TM
, press and hold
0 1-800-MSA-2222 / www.MSAnet.com
Button
button. Instrument performs a
screens,
use
TM
feature page through screens until
button.
WARNING
the
button
button.
from
the
button
10094850