Alcad SCM-030 Guia De Inicio Rapido

V I D E O P O R T E R O D I G I TA L - D I G I TA L V I D E O D O O R E N T R Y S Y S T E M S - V I D É O P O R T I E R N U M È R I Q U E
CONNECTION BRACKET
9630004 SCM-030 SOPORTE CONEXIONES MONITOR DIGITAL
9630004 SCM-030 DIGITAL MONITOR CONNECTION BRACKET
Support for wall fixing of the videodoor entry system monitor, for digital videodoor
entry systems. Element where all the video entry system's connections are done in the
flat/house, allowing connecting the monitor to the rest of the installation. The connection
system is as follows: a 2 wires communication BUS, 2 wires for the power supply of
Monitor and connection bracket size
the monitor and the coaxial cable for carrying the video signal. The communication
BUS does not have a connection polarity.
The connection bracket has a call volume control. It can be fixed to a wall or standard
electrical box fixing.
For the operation of the set monitor+connection bracket it is necessary to assign a code to each connection bracket that can identify it
within the installation (programming the connection bracket). This code is stored in the non-flash memory of the connection bracket.
It is possible to install up to 2 digital monitors and 2 digital telephones per house or flat on the same call line.
9630004 SCM-030 SUPPORT DE CONNEXIONS MONITEUR NUMERIQUE
RECOMENDACIONES - RECOMMENDATIONS - RECOMMANDATIONS
Choose an area of smooth, uniform and hard wall when deciding where to place the monitor. If the bracket is fixed to a standard flush-
mounted box, make sure that this is uniformly aligned. This way you will get an optimal fixing of the monitor.
Put it far from direct light sources, avoiding nonwhished effects in picture display (reflections,...). Same way avoid hard sources of heat,
humidity, steam, that could reduce the operational life of the equipment.