Bestway 52162 Manual Del Usuario página 2

1. The top of the barrier should be at least 48 inches above grade
measured on the side of the barrier which faces away from the
swimming pool. The maximum vertical clearance between grade and
the bottom of the barrier should be 4 inches measured on the side of
the barrier which faces away from the swimming pool. Where the top
of the pool structure is above grade, such as an aboveground pool,
the barrier may be at ground level, such as the pool structure, or
mounted on top of the pool structure. Where the barrier is mounted on
top of the pool structure, the maximum vertical clearance between the
top of the pool structure and the bottom of the barrier should be 4
inches.
2. Openings in the barrier should not allow passage of a 4-inch diameter
sphere.
3. Solid barriers, which do not have openings, such as a masonry or
stone wall, should not contain indentations or protrusions except for
normal construction tolerances and tooled masonry joints.
4. Where the barrier is composed of horizontal and vertical members and
the distance between the tops of the horizontal members is less than
45 inches, the horizontal members should be located on the swimming
pool side of the fence. Spacing between vertical members should not
exceed 1-3/4 inches in width. Where there are decorative cutouts,
spacing within the cutouts should not exceed 1-3/4 inches in width.
5. Where the barrier is composed of horizontal and vertical members and
the distance between the tops of the horizontal members is 45 inches
or more, spacing between vertical members should not exceed 4
inches. Where there are decorative cutouts, spacing within the cutouts
should not exceed 1-3/4 inches in width.
6. Maximum mesh size for chain link fences should not exceed 1-3/4
inch square unless the fence is provided with slats fastened at the top
or the bottom which reduce the openings to no more than 1-3/4
inches.
7. Where the barrier is composed of diagonal members, such as a lattice
fence, the maximum opening formed by the diagonal members should
be no more than 1-3/4 inches.
8. Access gates to the pool should comply with Section I, Paragraphs 1
through 7,and should be equipped to accommodate alocking device.
Pedestrian access gates should open outward, away from the pool,
and should be self-closing and have a self-latching device. Gates
other than pedestrian access gates should have a self-latching device.
Where the release mechanism of the self-latching device is located
less than 54 inches from the bottom of the gate, (a) the release
mechanism should be located on the pool side of the gate at least 3
inches below the top of the gate and (b) the gate and barrier should
have no opening greater than 1/2 inch within18 inches of the release
mechanism.
9. Where a wall of a dwelling serves aspart of the barrier, one of the
following should apply:
(a) All doors with direct access to the pool through that wall should be
equipped with an alarm which produces an audible warning when
the door and its screen, if present, are opened. The alarm should
sound continuously for a minimum of 30 seconds within 7 seconds
after the door is opened. Alarms should meet the requirements of
UL2017 General-Purpose Signaling Devices and Systems, Section
77. The alarm should have a minimum sound pressure rating of 85
dBA at 10 feet and the sound of the alarm should be distinctive
from other household sounds, such as smoke alarms, telephones,
and door bells. The alarm should automatically reset under all
conditions. The alarm should be equipped with manual means,
such as touchpads or switches, to temporarily deactivate the alarm
for a single opening of the door from either direction. Such
deactivation should last for nomore than 15 seconds. The
deactivation touchpads or switches should be located at least 54
inches above the threshold of the door.
(b) The pool should be equipped with a power safety cover which
complies with ASTM F1346-91 listed below.
(c) Other means of protection, such as self-closing doors with
self-latching devices, are acceptable so long as the degree of
protection afforded is not less than the protection afforded by (a) or
(b) described above.
10. Where an aboveground pool structure is used as a barrier or where
the barrier is mounted on top of the pool structure, and the means of
access is a ladder or steps, then (a) the ladder to the pool or steps
should be capable of being secured, locked or removed to prevent
access, or (b) the ladder or steps should be surrounded by a barrier
which meets Section I, Paragraphs 1 through 9. When the ladder or
steps are secured, locked, or removed,any opening created should
not allow the passage of a 4-inch diameter sphere.
Section II: Barrier Locations
Barriers should be located so as to prohibit permanent structures,
equipment or similar objects from being used to climb the barriers.
Preparation
Installation of small swimming pool usually takes only 10 minutes with 1
people.
Recommendations regarding placement of the pool:
• It is essential the pool is set up on solid, level ground. If the pool is set
up on uneven ground it can cause collapse of the pool and flooding,
causing serious personal injury and/or damage to personal property.
Setting up on uneven ground will void the warranty and service claims.
• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground
should be firm enough to withstand the pressure of the water; mud,
sand, soft / loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones
and twigs.
• Check with your local city council for by-laws relating to fencing, barriers,
lighting and safety requirements and ensure you comply with all laws.
Assembly
Warning: Adult assembly required.
1. Take the pool and accessories out of the carton with care and spread
out the pool on to the selected site.
2. Open the safety valves and inflate the parts one by one. Be sure to
close the valves after inflation. Air pump is not included.
NOTE: Do not over inflate. Do not use either an air compressor or
compressed air.
3. Slowly fill with water to pool just below the fill line on the pool's interior. Do
not exceed the fill line on the pool's interior. DO NOT OVERFILL as this
could cause the pool to collapse.
ATTENTION: Do not leave pool unattended while filling with water.
Proper Water Level
NOTE: All drawings for illustration purpose only. May not reflect actual
product. Not to scale.
Empty the pool
1. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. Deflate all the air chambers, at the same time push down the wall of
the pool to release the water. Make sure release all the water in 20
minutes.
NOTE: Drain by adult only!
Pool Maintenance
Warning: If you do not adhere to the maintenance guidelines covered
herein, your health might be at risk, especially that of your children.
• Change the water of pools frequently (particularly in hot weather) or when
noticeably contaminated, unclean water is harmful to the user's health.
• Please contact your local retailer to obtain chemicals to treat the water in
your pool. Be sure to follow the chemical manufacturer's instructions.
• Proper maintenance can maximize the life of your pool.
• See packaging for water capacity.
Cleaning and Storage
1. After use, use a damp cloth to gently clean all surfaces.
Note: Never use solvents or other chemicals that may damage the
product.
2. Air dry the pool, once pool is completely dry, fold pool carefully and
put back to its original packing. If pool is not completely dry, mould
may result and will damage the pool.
3. Store in a cool, dry place and out of children's reach.
4. Check the product for damage at the beginning of each season and at
regular intervals when in use.
Repair
If a chamber is damaged, use the provided repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
2
S-S-004300