Bushnell NatureView Manual Del Usuario página 8

USING the MINI TRIPOD
• Unfold the legs fully and set the tripod on a
stable, level surface such as a table or the ground.
• Attach the scope by lining up the screw at the
top of the tripod with the 1/4"-20 socket on the
bottom of the scope's tripod mounting base,
then turning the mounting knob on the tripod
until the scope is securely attached to the tripod
(do not overtighten).
• To tilt or rotate (pan) the spotting scope, twist the
pan handle counter-clockwise, move the scope
to the desired position, then tighten the pan
handle (clockwise) to hold it in place.
• To adjust the tripod height, loosen the height
lock collar, move the center column up or down,
then tighten the lock collar.
• To remove the car window mount section of the
tripod for separate use, loosen the large clamp
bolt fully and pull the top section off of the plate
at the top of the center column.
• When using the car window mount, roll your
window down part way and place the padded
clamp of the mount onto it, then carefully
tighten the clamp bolt (do not overtighten!).
Finally, attach the scope to the mounting screw.
8
Mounting Knob
Pan/Tilt Handle
Height Lock Collar
Center Column
Car Window Mount
Mounting Screw
Car Window Mount
Clamp Bolt
Plate (not visible)
Legs
Sun Shade Extended