Yakima LockNLoad Manual Del Usario página 9

2.5 Nm
CROSSBAR CLAMPS
PINCES CROSSBAR CLAMP
ABRAZADERAS PARA BARRA TRANSVERSAL
TIMBERLINE
TOWERS:
Install the
covers onto your
TimberLine towers.
4
TEST THE INSTALLATION.
Test the installation by pushing and pulling
in all directions. The Platform should
not slide or move on crossbars or pivot
mount. Retighten the mounting clamps or
mounting kit hardware if necessary.
Instruction #1035998G - Page 9 of 16
FINAL TIGHTENING • SERRAGE FINAL • AJUSTE FINAL
Now, fully tighten each Crossbar Clamp or TimberLine tower
(SkyLine towers are fixed so no tightening is required).
TIMBERLINE TOWERS
PIEDS TIMBERLINE
TORRES TIMBERLINE
3
purchased and
installed lock
cores for your
towers use your
SKS Key to lock
OPTIONAL: WIND
DEFLECTOR
REMOVAL
NOTE: The Wind Deflector can be removed
to suit certain anchors/accessories to be
used with the front extrusion. This is done
by simply peeling the part from the slot,
starting at one end and working across the
length of the deflector.
Installation is the reverse and should be
confirmed by hearing an audible 'CLICK'
when the deflector is fully installed.
3.5 Nm
LOCK YOUR TOWERS.
If you have
the towers.