Alarm (Alarm); Snooze Feature; Timer (Timer),(Max. 23:59:00) - Crivit 1-LD4657 Indicaciones Sobre Su Utilización Y Su Seguridad

Alarm (ALARM)

Press SEL to select the alarm sub-feature. Press and hold SET for 3
seconds to enter setting mode. „HOLD TO SET" will appear
on the display followed by „A1" and a blinking indicator „ - -
". Press SEL to activate the alarm „
ON
„ - - ". If the alarm is activated, the alarm symbol
appear on the display. Confirm your setting by pressing SET.
The minutes will blink on the display. Press SEL to set the minutes and press SET to
confirm your setting. Set the hours in the same way.
The month and day can now also be set if necessary.
Press SET to select one of the 5 available alarms A1-A5 and set the alarm as
described.
If neither the month nor the day is set, the alarm will sound
daily.
If only the month is set, the alarm will sound on every day of
the set month.
If only the day is set, the alarm will sound every month on the
set day.
If both the month and the day are set, the alarm will sound only
on the set date.
The hourly chime indicator will now blink on the display „CHIME". Press SEL
to activate or deactivate the hourly chime (ON, OFF) and confirm your setting
by pressing SET.
Bei aktiviertem Stundensignal erscheint das Glockensymbol
und es ertönt zu jeder vollen Stunde ein Signalton.
" or to deactivate the alarm
will
- 67 -
Exit setting mode by pressing MODE.
Press SET, SEL or MODE when the alarm sounds to stop the alarm.

Snooze feature

If no button is pressed when the alarm sounds, the alarm will sound again after 30
seconds and the symbol will appear on the display. The alarm will now stop for
approximately 90 seconds and then sound again. This process can be repeated 4
times.

Timer (TIMER),(max. 23:59:00)

Press SEL to select the sub-feature. Press and hold SET for 3 seconds to enter setting
mode. „HOLD TO SET" will appear on the display followed by the minutes of
the timer time. Press SEL to set the minutes and confirm your setting by pressing SET.
Set the hours in the same way. The additional setting for the timer follows. Press SEL
to select the desired mode:
After the timer reaches 0:00 it will count the set time
Cd r
again.
Cd U After the time reaches 0:00 it will count forward
Cd S After reaching 0:00 the timer will stop
Exit setting mode by pressing MODE.
Press SET to start or stop the timer.
After the set time is counted a beep will sound.
Press and hold SET to reset the timer.
- 68 -