Minimum Altitude; Total Altitude Gain; Total Altitude Loss; Number Of Hills - Crivit 1-LD4657 Indicaciones Sobre Su Utilización Y Su Seguridad

Press SET to show the current altitude/maximum altitude or
Temperature/time/diagram/maximum altitude.
Press and hold SET to reset the maximum altitude to the current altitude.

Minimum altitude

Press SEL to select the sub-feature (LOW). Press SET to show the current
altitude/minimum altitude or temperature/time/diagram/minimum altitude.
Press and hold SET to reset the minimum altitude to the current altitude.

Total altitude gain

Press SEL to select the sub-feature (UP). Press SET to show the current altitude/total
altitude gain or
temperature/time/diagram/total
altitude gain. Press and hold SET to reset
the total altitude gain.

Total altitude loss

Press SEL to select the sub-feature (DOWN). Press SET to show the current
altitude/total altitude loss or
temperature/time/diagram/total altitude
loss. Press and hold SET to reset the total
altitude loss.
- 73 -

Number of hills

Press SEL to select the sub-feature (HILL). Press SET to show the current altitude/hills
or temperature/time/diagram/hills.
Press and hold SET to reset the number of
hills.

Temperature

The temperature measured by the watch in measured within the case of the watch.
Please note that your body temperature can influence the reading.
To perform a temperature reading the watch should be removed from your arm and
then exposed to the outside temperature for 15 to 30 minutes.
Avoid placing the watch in direct sunlight.

Memory

Press SEL to select the sub-feature (RECORD). The values for the last 8 hours can be
shown on the display. Repeatedly press SET to show each value.
Press and hold SET to reset the memory.
Exit Memory mode by pressing MODE.

Troubleshooting

Incorrect compass reading
Incorrect calibration or external influences (change of location).
Calibrate the compass as described in this manual.
Error message " ERROR " when using the compass feature.
External magnetic influences (for example: metal objects, electronic or electrical
devices, computers, transformers or power lines). Move to a different location and
repeat calibration.
Display becomes weaker or shows incorrect values
Batteries weak or dirty/corroded contacts.
Replace the batteries and clean the contacts using a dry, lint-free cloth.
Black display
Outside temperature too high; possibly cause by prolonged and direct exposure to
sunlight.
- 74 -