BABYZEN YOYO Manual De Usario página 11

en
Installation of backrest
1. Using a coin, retract the white pin.
2. Insert backrest from the front.
3. On the right hand side of backrest
(the side that does not have white
pin), mount hinge into the stroller
frame.
4. On the left hand side of backrest,
align hinge.
5. Push white pin in to lock the backrest
into position.
Installation of basket and shoulder
strap
1. Hook shoulder strap to the rings
underneath seat.
2. & 3. Secure the four straps on front
of basket by looping through slots
located on footrest.
4. & 5. On the rear rim of basket, secure
the straps by looping through the slots
located on rear legs.
Installation of seat base
1. Insert large metal wire inside the front
rim of the canopy.
2. Mount seat base fabrics over
backrest. Under the seat base fabrics,
secure the two straps by inserting into
the corresponding slots in seat base.
3. Slot plastic clips onto both sides of
stroller frame.
10
4. Insert ends of the large wire into the
external mounts of the handlebar, and
secure with cord loops.
5. Secure the straps around the tube
under the seat, and close the buckles.
Installation of seat pad and harness
1. Thread the harness shoulder straps
through one of the three pairs of slots
on the pad, according to the height of
your child.
2. Thread the harness waist straps through
the slots on the pad.
3. Thread the harness crotch strap
through the slot on the pad.
4. Affix the front loop of seat pad to the
hook under seat.
Folding the YOYO
+
1. Using your thumbs, simultaneously
press the two buttons to unlock the
handlebar.
2. Recline the handlebar towards
backrest.
3. Grasp the red latch under the seat,
and press the security button with your
finger.
4. While pressing on the security button,
simultaneously pull the red latch
towards you, until you hear a 'click'.
5. Completely release the red latch.
6. Hold only the shiny carrying handle bar.
/YOYO 0+
2