Yakima DryDock Manual Del Usuario página 4

Portador diseñado para kayaks o canoas de recreo
Ocultar thumbs Ver también para DryDock:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• INSERT THE CROSSBAR
through the holes in the
support arms.
SECURE THE CROSSBAR.
• Tighten
crossbar
clamps using
the hex
wrench.
• Tighten until crossbar cannot rotate.
• DO NOT OVER TIGHTEN!
SECURE THE CARRIER.
INSERT hitch bolt and
washer from RIGHT
TO LEFT.
1033016C - 4/18
Crossbar sold separately.
Minimum 58" crossbar required.
SECURE hitch bolt
with safety clip.
TIGHTEN bolt.
SLIDE stabilizing straps
onto crossbar during
installation.
INSTALL END CAPS.
Push end caps onto
ends of crossbar.
TEST THE INSTALLATION.
Twist the crossbar.
If it can rotate—TIGHTEN bar
clamps using the hex wrench.
DO NOT OVER TIGHTEN.
CENTER THE BAR.
ATTACH ASSEMBLED
DRYDOCK.
The hole in the hitch
must align with the hole
in the DryDock.
If you have purchased the
QuickHitch, install it now.
COMPLETE STRAP
ASSEMBLY.
Depress tab in
buckle and insert
strap end.

Publicidad

Tabla de contenido
loading

Tabla de contenido