Connecting 1762 I/O Expansion Modules - Rockwell Automation MicroLogix 1200 Manual Del Usuario

12 MicroLogix™ 1200 Programmable Controllers

Connecting 1762 I/O Expansion Modules

ATTENTION: Remove power to the system before installing
expansion I/O or damage to the controller may result.
!
Connect 1762 I/O after mounting the controller. Remove the expansion port
cover to install expansion I/O modules. Plug the ribbon cable connector into the
bus connector. Replace the cover as shown below.
Important: Ensure that your system power supply is sufficient to support the
number of I/O modules you are installing in the system. A system
loading worksheet is provided in the MicroLogix 1200 Programmable
Controllers User Manual, publication 1762-UM001A-US-P.
For detailed information on using expansion I/O, refer to the installation
instructions for your expansion module.
1762-IN006A-ML-P