Matrix E30 Manual Del Usuario página 5

A Open HARDWARE FOR STEP 1.
1
B Remove 4 PRE-INSTALLED SCREWS (5) and
TOP CAP COVER (6)from MAIN FRAME (4).
C Carefully pull the CABLE (1) through the
CONSOLE MAST (2) using the LEAD WIRE
(3) located inside the CONSOLE MAST (2).
D Attach CONSOLE MAST (2) to MAIN FRAME (4)
using 4 BOLTS (A) and 4 FLAT WASHERS (B).
E Attach the TOP CAP COVER (6) to the MAIN
FRAME (4) using 4 PRE-INSTALLED SCREWS (5).
F Attach the CONSOLE MAST BOOT (7) to the
TOP CAP COVER (6) by snapping it into place.
7 2
1
2
Hardware For Step 1
Description Qty
A Bolt 4
B Flat Washer 4
Note: Be careful not to pinch
any wires while attaching the
upper assembly.
3
1
A
B
5
6
4 5
A Open HARDWARE FOR STEP 2.
B Slide 1 FLAT WASHER (C), 1 WAVY
WASHER (D) and 1 FLAT WASHER
(C) onto CONSOLE MAST (2).
C Slide LOWER DUAL ACTION ARM
(8) onto the CONSOLE MAST (2)
D Attach using 1 FLAT WASHER
(F), 1 FLAT WASHER (E), 1
HANDLEBAR CAP (9), 1 FLAT
WASHER (F), 1 SPRING WASHER
(G) and 1 BOLT (H). Torque
settings: 64.5 Nm / 47.6 lb-ft.
E Repeat on other side.
2 C
Hardware For Step 3
Description Qty
C Flat Washer (27 mm) 4
D Wavy Washer 2
E Flat Washer (26 mm) 2
F Flat Washer (20 mm) 4
G Spring Washer 2
H Bolt 2
8
F
G
H
D
E
9
5