Publicidad
NOTE: If you wish to use DoubleHaul in its half-sized configuration, proceed to page 5.
1
JOIN THE TWO HALVES TOGETHER.
2
LOOSEN THE MOUNTING PLATES.
Turn the thumbscrews
on the mounting
plates a few turns to
allow the mounting
plate to slide freely.
Instruction #1035940E - Page 2 of 9
INSTALLATION • INSTALLATION • INSTALACIÓN
Join the front and rear halves
together with the couplers. Using the
6 mm hex wrench and the 13 x 19 mm
open wrench. Install the hardware as
shown. Tighten to 10 Nm.
4X
4X
2X
2X
Publicidad
