3M 05846 Manual Del Usario página 4

To reduce the risks associated with air pressure:
• Never attempt to connect this tool to bottled gasses such as CO
use with air from industrial style compressors.
• Ensure regulated air input is 145 psi (10 BAR) maximum and that the dispenser feed rate regulator is properly adjusted prior to each use.
• Do not alter or modify the dispenser and use only 3M approved service parts.
• Check the dispenser air pressure regulator and all other air pressurized components for secure attachment and damage daily and replace
all worn or damaged parts prior to use.
• Ensure line air supply is adequately conditioned for the dispenser system and the application.
• Follow required air pressure relief procedures for relieving air pressure from the unit.
To reduce the risks associated with impact:
• Handle and operate the dispenser with both hands to prevent dropping the unit.
• Route supply line air hose away from traffic areas, sharp edges, moving parts and hot surfaces to prevent tripping and component failure.
To reduce the risks associated with environmental contamination:
• Dispose of uncured material, used material cartridges and nozzles per federal, state and local regulations.
To reduce the risks associated with entanglement:
• Properly secure any loose clothing, hair, or similar items when operating the 3M™ Dynamic Mixing Gun - Pneumatic. The dispenser
contains an external rotating socket located in the center of the cartridge mounting plate.
To maximize the life of the system:
• DO NOT operate the dispenser without a properly attached cartridge for the 3M™ Dynamic Mixing System.
• DO NOT operate the dispenser without first replacing mixing nozzles that have accumulated cured material in them (PN 05847).
• DO NOT attempt to refill the cartridge for the 3M™ Dynamic Mixing System (e.g. PN 05850 or 05857).
*Vibration level: less than 2.5m/s²
Declared vibration level in accordance with EN 12096, measurements carried out in accordance with standard EN ISO 28662-1
*Noise Level: 87.6dBA
Declared noise level in accordance with ISO 4871, measurements carried out in accordance with standard EN ISO 15744.
It is recommended to wear ear protection while using the applicator.
*"The noise and vibration values stated are from laboratory testing in conformity with stated codes and standards and are not sufficient risk evaluation for all exposure
scenarios. Values measured in a particular work place may be higher than the declared values. The actual exposure values and amount of risk or harm experienced to an
individual is unique to each situation and depends upon the surrounding environment, the way in which the individual works, the particular material being worked, work
station design, as well as upon the exposure time and the physical condition of the user. 3M cannot be held responsible for the consequences of using declared values
instead of actual exposure values for any individual risk assessment."
CAUTION
or Nitrogen. The 3M™ Dynamic Mixing Gun - Pneumatic is intended for
2
NOTICE
2
3