Installation; Assembly - Indesit H562 IX Instrucciones De Uso

Installation

Assembly

GB
Before proceeding with the assembly operations,
remove the metal grille so that the hood is easier
to handle (for the instructions see the paragraph
"Cleaning the grease filter" in the chapter on
"Maintenance").
Fixing to the wall
1) Draw a line on the wall along the vertical axis of
the hob. Mark the 4 holes (A and B) to be drilled
on the wall, respecting the measurements
indicated in the figure below.
2) Drill the holes (8 mm ø) and fit the 4 screw
anchors provided.
3) Fit only 2 screws in the topmost holes (A) and
hook the hood onto them.
4) Proceed with final fixing using a further 2 screws
in the holes (B).
5) Only for the ducting versions:
- set the flange (M) over the motor and press
slightly.
- the air vent of the hood has a diameter of 150
mm; if you need a smaller diameter, fit the
reducer (C).
10
Securing the decorative flue
1) Place the bracket (C) 50 mm from the ceiling and
position it on the vertical axis of the hood.
With a felt-tip pen, mark the 2 holes on the wall;
drill the 2 holes and fit 2 screw anchors.
2) Fix the bracket to the wall using 2 screws (E).
3) Only for the ducting versions: Connect the air vent
of the hood to the air vent hole using a flexible
hose (F) of 150 mm diameter. Lock the flexible
hose with some metal hose clamps (hose and
clamps not provided).