Additional Safety Warnings - MIRKA Deros Instrucciones De Manejo

WARNING
• Always wear required personal safety protection in accordance with manufacturer's instructions and local/national
standards while using this tool
• The electrical safety of the tool is granted only by using original Mirka backing pads
• Do not use a power tool if you are tired or under the influence of drugs, alcohol or medication
• Read the Materials Safety Data Sheet (MSDS) for the work surface
• Use the tool with dust extraction A suitable dust extraction unit will reduce hazardous dust
• Do not overreach The operator must always stand in a secure position with a firm grip and firm footing on a solid
floor
• Do not wear loose clothing or jewellery Keep hair, clothing and gloves away from moving parts Loose clothes,
jewellery or long hair can get caught in moving parts
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust
Power tools create sparks which may ignite the dust or fumes
CAUTION
• Remove pad wrench before connecting the tool to the power source
• Keep work area clean and well lit
• Always ensure that the work piece to be sanded is firmly fixed in place
• Before changing the abrasive always disconnect the power source Make sure the abrasive is perfectly centred and
firmly attached to the backing pad
• Keep children and bystanders away while operating a power tool Distractions can cause you to lose control of the
tool
• Always pay attention to work safety Never carry, store or leave the tool unattended with the power source
connected
• Keep hands clear of the spinning pad during use
• Do not allow the tool to free speed without taking precautions to protect surrounding people and objects in the
event that the abrasive or backing pad should come loose

Additional safety warnings

• Read all instructions before using this tool All operators must be fully trained in the proper, safe use of this tool
• All maintenance must be carried out by trained personnel For service, contact a Mirka authorized service centre
• Always use the tools with a residual current device (RCD) with a rated residual current of 30 mA or less
• The power supply socket and connector are non-IEC appliance couplers Only use an original Mirka power supply
cable The Mirka power supply cable can be bought from your Mirka Dealer
• Check the tool, backing pad, power cord and fittings regularly for wear
• Clean or replace the dust extractor´s collection bag daily Dust can be highly combustible Cleaning or replacing the
bag also assures optimum performance
• Always ensure that the power tool specifications correspond to the power source (V, Hz)
• Take care to prevent clothing, ties, hair, cleaning rags, etc from getting caught in the tool's moving parts
• If the tool appears to malfunction, stop using it immediately and arrange for service and repair
Mirka® DEROS • 77 mm (3"), 125 mm (5") & 150 mm (6") • 230 V
en
59