Additional Safety Warnings - MIRKA ARP-B 300NV Instrucciones De Manejo

Tabla de contenido

Idiomas disponibles

Store idle power tools out of the reach of children and do not anyone who is unfamiliar with the

power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of

untrained users.

Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and

any other condition that may affect the power tool's operation. If damaged, have the power tool

repaired before use. Many accidents are caused by poorly maintained power tools.

Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less

likely to bind and are easier to control.

Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into

account the working conditions and the work to be performed. Use of the power tool for operations

different from those intended could result in a hazardous situation.

Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles and

grasping surfaces do not allow for safe handling and control of the tool in unexpected situations.

Service

Have your power tool serviced by a qualified repair person using only identical replacement parts.

This will ensure that the safety of the power tool is maintained.

Battery tool use and care

Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type

of battery pack may create a risk of fire when used with another battery pack.

Use power tools only with specifically designated battery packs. Use of any other battery packs may

create a risk of injury and fire.

When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys,

nails, screws or other small metal objects, that can make a connection from one terminal to another.

Shorting the battery terminals together may cause burns or a fire.

Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally

occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from

the battery may cause irritation or burns.

Please read and comply with

General Industry Safety & Health Regulations, part 1910, OSHA 2206, available from: Superintendent of Documents;

Government Printing Office; Washington DC 20402

State and local regulations

Safety rules for battery pack and charger

Important safety and operating instructions for your battery and charger. Before using the charger, read all instructions

and warnings on the charger, the battery pack and the tool.

If the battery pack casing is cracked or damaged, do not insert into charger. There is a danger of electric shock or

electrocution.

Do not allow any liquid to get inside charger. Electric shock may result.

This charger is not intended for any uses other than charging rechargeable batteries.

Do not place any object on top of the charger, near any heat source or place the charger on a soft surface that may

result in excessive internal heat.

Make sure the cord is located so it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

Do not use the charger if it has received a sharp blow, been dropped or otherwise damaged in any way.

Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 50 °C (122 °F).

The charger is designed to operate on standard household electrical power (100 240 VAC). Do not attempt to use it

on any other voltage.