PLYMOVENT MiniMan-100 Instrucciones Para El Uso página 11

Ocultar thumbs Ver también para MiniMan-100:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

MiniMan
a. if the inner arm seems to be too weak or too strong:
Check that the arm is correctly assembled on the wall. Also
1.
check that the wall bracket is level.
Check and adjust the friction joints marked a on the figure.
2.
B. if the outer arm will not stay in the required position:
Check that the arm is correctly assembled. Also check that the
1.
wall bracket is level.
Check and adjust the friction joints marked b on the figure.
2.
c. if the hood will not stay in the required position:
Adjust the friction(see picture) until the hood will stay in the
1.
exact position.
021213/0 MiniMan-100
B
a
MainTenance insTrucTion
© Copyright 2008: All rights reserved. All information within this printed matter may not be reproduced,
handed over, copied, xeroxed or translated into another language in any form or means without written
permission from Plymovent AB. Plymovent AB reserves the right to make design changes.
a
BSAB no: T0.31
Ser. no: MM/DS
Date: Aug-00
Replace:
B
Miniman/100/USA/CAN/12/14
EN - 10

Publicidad

Tabla de contenido
loading

Tabla de contenido