PLYMOVENT MiniMan-100 Instrucciones Para El Uso página 9

3. If you have purchased a damper kit D-100 and wish to install it, please continue to follow the steps below. If you have purcha-
sed a halogen lamp cartridge HL-20/24-100 and want to install it you can go to step no.7.
4. Remove the stickers covering the mounting holes(a) for the damper and the hose between the hood and the outer tube(b) and
mount the "ratchet"(c) to the top of the tube using the supplied pop-rivet(d).
5. Place damper blade(a) inside outer tube(b) Put the ball cassette inside the hole in the pointy part of the damper turning knob(d)
and insert the damper shaft(c) from the top side of the tube thru the damper blade, you may have to tapp it in place with a ham-
mer. Align the knob with the damper blade in sutch a way that knob is pointing along the tube when the damper is fully open
(e) secure damper blade to the shaft with the supplied "grabber screw". Correct position of the turning knob is when there are
approximately 1mm, 0.04" between the damper ratchet and knob. Assemble in order the ponge rubber washer, spring vasher
and star-lock vasher at the damper shaft.
A
C
6. Reattach the hose between hood and outer tube. you have now completed the installation of the damper kit.
021213/0 MiniMan-100
A
B
E
B
C
D
D
EN - 8