Replacement Parts - decorflame MM360-52GCN Manual Del Usuario

REPAIRS
If any problems are found with the original parts during mantel assembly such as the
panels cannot be installed with the plastic connector. Try to solve by one of the following
methods.
Tools required: Electric drill, drill bit 10 mm (3/4 in) or 2 mm (1/16 in), pencil, hammer,
Phillips screwdriver, safety goggles and gloves (if necessary).
warNiNG: wEar GOGGlES BEFOrE yOU Start DrilliNG.
OptiON 1:
Use the spare nuts, screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes, as shown in
Fig. A.
2. Drill the holes with diameter 3/4 in (10 mm) and depth 3/4 in (10mm) on the mantel.
Each plastic connector needs 3 holes. See Fig.B.
Fig. B
3. Gently install the nuts into the drilled-holes with hammer, as shown in Fig. C.
4. Attach the plastic connector and lock in place with screws, as shown in Fig. D.
Fig. A
Fig. C
Fig. D Back
OptiON 2:
Use the small L-brackets and screws.
1. Place the small L-bracket to the unit as shown and mark the drill-holes on the mantel,
as shown in Fig. E.
2. Drill the holes with diameter 2 mm (1/16 in) and depth 8mm (5/16 in) on the mantel.
Each small L-bracket needs 4 holes. See Fig. F.
Fig. F
3. Attach the small L-bracket and lock in place with screws, as shown in Fig. G.
CLEANING
To clean unit, first turn off controls on unit and unplug the unit from power source. To
clean glass display panel, remove dust with clean dry cloth. Remove finger prints and
other marks clean glass with clean damp cloth. Do not use abrasive cleaners or spray
liquids on glass display panel surface. Metal and metal painted parts should be cleaned
with damp cloth. Do not use abrasive cleaners or spray liquids on these surfaces.

REPLACEMENT PARTS

itEM
Hardware kit
Self repair kit
Remote control
6
Fig. E
Fig. G
part #
360-52-HW#1
REKIT
110BL-RM#1
qty
1
1
1