Klarstein HIGH 10033053 Manual Del Usuario página 24

EN
24
• When mounting a non-return valve, it must be ensured that the valve can be opened
freely. If the valve cannot be opened freely, it can reduce the suction power and
increase the noise from the extractor hood.
• If the extractor hood is used for recirculation and there is no external ventilation
(exhaust air), it is important that the ventilation is not blocked or impaired, as this
can damage the extractor hood, reduce capacity and increase noise. In addition,
no non-return valve can be installed in recirculation mode.
Installation (Vent inside)
If you do not have an outlet to the outside, exhaust pipe is not required and the
installation is similar to the one show in section "Installation (Vent outside)".
Installing the Carbon Filter
Note: An activated carbon filter is not included. But you can buy it as an extractor
hood.
Activated
carbon filter
Installation plate
for the filter
The filter is
located before
the air outlet